Knowledgebase
Installation of Quick Heal Total Security for Android V 2 (STEP BY STEP PROCEDURE)
Posted by Premsai B. on 28 October 2014 04:50 PM

If you are looking for the assistance for installing Quick Heal Total Security for Andorid in you phone, kindly find below steps, which will helps in getting the Quick Heal Total Security for Android.

How to download Quick Heal total Security for Android:

To download the installer for Quick Heal Total Security, visit the below weblink from your device. 

www.quickheal.com/qhmts

Once the above page is loaded, click on "Download" to start downloading the Quick Heal installer. (Kindly refer the below image)

 Once the download is sucessfully completed Run the .apk installer to start the installation.

Click on "Package Installer" and Proceed with the steps

You will be prompted to Click on "Install" once the installer is executed. 

You will get the below installation confirmaiton and will be promoted to click on "Open" for the Quick Heal activation.

For the activation of Quick Heal Total Security for Android after sucessfull installation, your Quick Heal will starts scanning the device.

 

Once Quick Heal scan is completed, you will be prompted with the activation steps, Click on I agree to proceed with the license agreement

You will be prompted to provide your 20 digit product key, enter the same and click on "Next"

 

Once the product key is submitted, you will prompted to provide your registration information (ie) User Name and Email Id. 

Once the registration information are entered proceed by clicking on "Next". Further you will be prompted to enter the Quick Heal Settings Password. Provide the same and click on "Next".

 

 

 

 

Once the password is provided, you will be prompted to configured the alternative number which shall be used to send the SMS on Sim change and for sending One Time Password for the password change. Provide the alternate number and tap on "+" to add the number and proceed by clicking on "Next".

Once the above steps are done, you will be prompted to allow the Quick Heal under device administrator. Click on "Activate".

 

 

 Further, to verify the installed device's mobile number, Quick Heal will prompts to send a sms. Provide the mobile number and click on "Activate".

Once the number is provided, this will send a sms to verify the mobile number (*Carrier charges may apply)

After the above steps, the installed Quick Heal will starts working and you can configure the settings according to your requirement. 

(6 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: